There are two situations when there are warped edges in the artificial lawn. One is that there are warped edges during construction, and there is a warped edge in the process of use. The former is easier to solve, because the construction is not finished yet, the latter is more troublesome, because it is finished, and rework is very troublesome in the process of use.
The reason why it is simple in the construction of artificial turf is that it can be reworked at any time. At this time, there are two reasons for warping. One is the lack of glue, the sticking and the unsteady, and the other is the warped edge caused by the long drying time after the glue is applied. This should be careful to apply glue to a moderate amount, not too big, certainly not too little, too much drying time, and in very individual cases will also cause warping. After applying the glue, let dry for about five to ten minutes, or you can try to stick and stick to a small piece. In general, it is difficult to pull apart when the strength is stronger, and it can be sticky when the glue is pulled back. At this time the surface of the glue is no flowing glue, it has been dry almost.
The area that has been used is the most troublesome, and the maintenance is rather troublesome. This needs to be filled with quartz sand and rubber granules is clean, then put the lawn clean dirt on viscosity and below, after the adhesive and good, then fill of quartz sand and rubber granules is good, this is, it is very simple but true to the construction is very troublesome, especially the cleaning and filling, quartz sand and rubber particles do closely linking to the original is very difficult. Therefore, we should pay more attention to the construction, take it seriously and make it a success.
